| Daily | - Clean both the inside and outside surface of the door with a clean damp cloth & mild soap solution.
- Wipe all surfaces and make sure that it is dry.
- Do not use any harsh cleaning liquids such as ammonia-based products. The interior and exterior of the door are either Acrylume, or Stainless Steel, any difficult stains should be cleaned with a non-abrasive metal polish.
- The floor panels should be cleaned using a warm soapy solution or an approved NSF cleaning solution. Do not allow puddles to build up on the floor. Do not use any harsh chemicals to clean the floor.
|
|---|
| Weekly | - Inspect Thermocouple placement
- Inspect the door to ensure proper closure and that nothing is interfering with the door from closing.
- Check the thresholds on the door to ensure they are secure and secured to the concrete panel.
|
|---|
| Monthly | - Clean gaskets and door sweep. Use a warm water solution (one part baking soda) & dry all gaskets after cleaning.
- Inspect the inside release mechanism to ensure proper operation.
- Inspect light fixtures and observe for any moisture intrusion.
- Inspect interior walls for missing cam lock plug holes. If missing, replace immediately to prevent moisture from entering.
- Make sure that there are no obstructions around the unit.
|
|---|
| Quarterly | - Inspect the compressor for leaks, excessive moisture, and accumulation of dirt and debris.
- Check for unusual noise or vibration.
- Inspect wiring for signs of wear or discoloration and repair if needed.
- Check and tighten all flare connections.
|
|---|
| Bi-Annually | - Inspect door gaskets and sweeps (replacements may be needed every three years)
- Preventative maintenance appointment completed by qualified service technician recommended every 6-12 months
- Clean evaporator/condenser coil and blades
- Check the operation of all fans and ensure airflow is unobstructed.
- Inspect electrical wiring and components
- Check refrigeration cycle to ensure proper operation
|
|---|
| Annually | - Inspect door hinges
- Inspect fastening hardware to make sure that they are tight and secure
- Preventative maintenance appointment completed by qualified service technician recommended every 6-12 months
|
|---|
